Transferring patterns onto a surface to then pinstripe can be done a few ways. Pouncing a pattern is one of the many ways.
Either drawing a design or printing one out you can still use a pounce wheel to puncture tiny holes in the design.
After all lines and areas have been pounced you can tape the design on the intended surface and dab graphene powder over the design. The graphene powder will fill the tiny holes leaving a "connect the dots" design after the paper is removed.
Any extra graphene powder can be blown off the surface to leave a basic design. Once the design is striped and dried you can wipe off any left over powder.
See the YouTube tutorial here:
